Bike tools
TL-FH12 hub setting tool 12mm thru axle is product number 13 in the attached image. Genuine Shimano replacement part.
Tough genuine Shimano tools. Hardened steel for longevity and durability.
Use to cut cable outer casing, cables and for pinching cable end caps and ferrules. Contoured handles for comfortable grip. Sprung jaws. Section for pinching cable end caps and ferrules without cutting them.
Tough genuine Shimano tool.
Tough genuine Shimano tool.
TL-BME02 Battery mount setting tool for BM-E8010 (BT-E8010) is product number 14 in the attached image. Genuine Shimano replacement part.
Tough genuine Shimano tools. Hardened steel for longevity and durability.
Tough genuine Shimano tools. Hardened steel for longevity and durability.
Ergonomic sprocket remover tool for 1-1/8 inch size sprockets. comfortable handle grip. For use with 1-1/8 sprockets.
Tough genuine Shimano tools. Hardened steel for longevity and durability.
Tough genuine Shimano tools. Hardened steel for longevity and durability.
A simple adaptor to allow the use of a standard crank extractor tool with Shimano Octalink splined cranks.
MAHLE X35+ specific tool to open the drive unit.Mandatory to change the freewheel on the X35 system.Includes bolts.
This tool allows the removal of MAHLE bottom bracket bearings without disassembling them from the bike, significantly reducing the risk of damage and improving maintenance efficiency.
The EDC Tool Chainbreaker Kit includes the chainbreaker and bolt to attach to the EDC storage carrier. The EDC Tool Chainbreaker Kit V2 is not compatible with the EDC Tool Frame Kit V1. KIT CONTAINS . Chainbreaker. Spare Bolt .
Easy to install. Easy to carry. And compatible with pretty much any bike with a steerer tube. The included 9 function Multi Tool contains your most used tools and lives inside your stem/steerer tube.
44 tooth ratchets and springs for OneUp Rear Hubs. Includes a packet of Dumondeâ„¢ Tech Pro X Freehub Grease.
Bearing installation tool for non-drive side bearings on rear Mon Chasseral wheels. Please consult your wheel's service manual before ordering this tool to see whether it is required.
Tooling for removing and installing the end cap retention rings as used on 15 mm front axle 350 and 370 hubs. Includes drift and guide to ensure perfect alignment when working on these hubs.
TL-FH17A seal ring presser is product number 28 in the attached image. Genuine Shimano replacement part.
Adaptor for using Lefty Hubs in the DT Proline professional truing stand.
A special tool for holding Aerolite bladed spokes whilst wheel building or truing. Holds bladed spoke securely and allows nipples to be tensioned. Designed to be used in conjunction with TLDT108 nipple wrench.
A special tool for holding 0.6 - 0.8 mm bladed spokes whilst wheel building or truing. Holds bladed spoke securely and allows nipples to be tensioned. Designed to be used in conjunction with TLDT108 nipple wrench.
Sealed bearing extractor for 30mm ID bearingsExtractor has 1/2" thru hole for use with our 1/2" threaded rod press handles.
